The video, produced by the Centers for Disease Control and Prevention (CDC), demonstrates on donning and doffing a laboratory coat, gloves and safety glasses with wrap around sides.

This video, produced by 3M, demonstrates how safety eyewear provides protection against impacts.

This video, produced by Northwestern University, introduces the potential pathways by which chemicals can break through the protection of gloves, including penetration and permeation. It also provides general guidance for selecting appropriate gloves based on the nature of the experiment and chemicals used.

This video, produced by ADVSafety, demonstrates permeation test comparing the protection of latex and nitrile gloves against chemical exposure. 

This video from Ansell shows the proper steps to remove single-use gloves to prevent contamination of your hands.

This video, produced by 3M™, introduces the design and use of a half-face respirator, covering preparation, proper donning and maintenance procedures.

Session 1: Introduction (0-1:29) 

Session 2: Use and limitation (1:30-3:27) 

Session 3: Inspection (3:28-3:53) 

Session 4: Assembly (3:54-7:27) 

Session 5&6: Donning and removal (7:28-11:22) 

Session 7: Replacement and cleaning (11:23-12:50) 

Session 8: Replacement parts (12:51-15:10) 

This video, produced by 3M™, introduces the design and use of a full-face respirator, covering preparation, proper donning and maintenance procedures.

This video from 3M shows the working principle of a service life indicator of chemical cartridges and how to determine the end of their service life.

This video, produced by 3M demonstrates how to conduct a seal check, a crucial step to confirm the proper fit and prevent inward leakage of contaminants.

This video, produced by 3M demonstrates how reusable respirators work, highlighting common mistakes to avoid for effective protection against diverse airborne hazards.

Section 1: Introduction (00:00 – 00:39)

Section 2: Components of respirators (00:40 – 01:20)

Section 3: Cartidges and Filters (01:21 – 02:18)

Section 4: Not obtaining a proper fit (02:19 – 02:54)

Seciton 5: Not ensuring proper assembly (02:55 – 03:32)

Seciton 6: Not replacing cartridges and filters (03:33 to 03:45)

Section 7: Not using a prefilter (03:46 to 04:29)

Section 8: Not maintaining good hygiene (04:30 – 05:07)

This video, produced by 3M introduces reusable respirators and their versatility (filtering particles, gases, vapors), emphasizing fit, filter selection using the NIOSH filter matrix and color codes, timely replacement, and hygiene for optimal protection.

This 3M video demonstrates when to replace disposable respirators, cartridges, or filters, covering usage frequency, shelf life, time limits for disposables, factors affecting cartridge shelf life, and estimating it using the 3M™ Service Life Calculator.

This video from 3M Personal Safety shows the correct method of inserting roll-down earplugs. Watch this video to ensure you're filling your roll-down earplugs correctly as an incorrect fitting can result in a reduced attenuation ability.

This video from 3M Personal Safety shows the correct method of inserting pre-moulded earplugs. Watch this video to ensure you're filling your pre-moulded earplugs correctly as an incorrect fitting can result in a reduced attenuation ability.

This video from 3M Personal Safety shows you how to fit your 3M helmet-mounted and headband ear defenders.